baseball template for scanning baseball cards
 

Is there a place where I can get a template to use when I am scanning
baseball cards so to keep them straight?

Not really a "template" but I use a SGC gasket from a cracked slab to line up even scans. For graded cards I'll place the gasket against the bottom edge of the scanner and just slide the slab up against the gasket. Same for raw cards, I'll almost universally scan them in a One Touch pressed up against the gasket.
For add size cards I don't have a recessed holder to scan them in I'll placed the gasket against the right of left side of the scanner about half way and level the card against the gasket. Then I'll use a business card to lift the gasket off the scanner bed and 99% of the time you have a level scan.

One of my favorite webcasts touches on this topic a lot
 

If you use You Tube and put in
One Million Cubs Scanning you will get a bunch of videos to watch

https://www.youtube.com/results?sear...+cubs+scanning

Regards
Rich

I just use a business card as a gap fillter between the scanner edge and the card I want to scan.