Posted By:
JKJeff,
A few suggestions - you can try a very small piece of tape across one side of each top opening - works well with sgc cards and is barely noticable (take a look at my pics above and you will see the tape). The bottom cards are held in by the top cards and shouldnt be a problem. You can also try putting each slab inside a graded card sleeve and then into the ultrapro page - the card sleeve takes up some of the extra space and keeps the smaller slabs from moving as much. One last trick if you use card sleeves is to fold the flap of the card sleeve on the two top cards over the back of the ultra pro sheet and affix to the back of the ultra pro sheet rather than the back of the slab - this will keep them from moving at all.