Quote:
Originally Posted by sb1
The horizontal/vertical layout may be the reason that a lot of t207's are cut short top to bottom but are 100% original, they were the horizontal cards on the layout.?? They would have had to cut vertically first and then cut the remaining horizontals apart, which could also be the reason for the number of diagonal top and bottom cuts on some of the shorter cards.
Just a thought.
|
Quote:
Originally Posted by frohme
I think you're dead on, Scott.
There are a variety of cards you find with MC and OC on the other axis, or more MC/OC than other cards. Needing to make those cuts would seem to drive more process failures (so to speak) on that set of cards.
--
Mike
|
Not being an expert on the set I always assumed this card was trimmed because of how small it is. Is it possible that it isn't trimmed but factory cut short?
