[Archive]

Posted By: Julie

and crack off pieces (not too close to the card. Start at the top where the label is, and when you have the label-part all off, ther two halves should come apart. If not, start carefully down the side, until they two parts do comer apart.

If it's just like a PSA, but with a really tight seal, just keep sawing between the two sides with a sharp knife--it just takes longer--until you're about 3/8th of an inch in (again, from the top, where the label is), and then try to turn the knife to 45 degrees, It should work. Start at the corners and work in (you may have to do both corners--or all four).

The tool mentioned above I don't have. I'm sure it works quite well.