 |
|
||||||
 |
|
|||||
 |
 |
 |
 |
 |
 |
 |
 |
|
|
||||||
|
|
|||||
|
|
|
|
|
|
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
|
#15
04-12-2013, 10:51 AM
|
||||
|
||||
So do the edges HAVE to be parallel? I had, and resold, a psa 4 card where the sides were not parallel equating to a slightly shorter top edge than bottom. I thought this always meant a trim, no further investigation needed. In this case all 4 corners were worn evenly, the edges all "matched", I was unable to look at the side of the card but everything looked ok and it was only a $100 card...no Wagners here. I thought this always meant it was trimmed as diamond cuts still have parallel edges, just not perpendicular. Am I wrong?
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| For Trade: Two trimmed (I mean really trimmed) EPDG - SOLD | t206hound | Tobacco (T) cards, except T206 B/S/T | 0 | 02-27-2013 10:28 AM |
| (1) Trimmed T205 and (1) Trimmed T206 | Archive | Tobacco (T) cards, except T206 B/S/T | 0 | 06-21-2008 12:54 PM |
| does this card look trimmed to you? | Archive | Net54baseball Vintage (WWII & Older) Baseball Cards & New Member Introductions | 4 | 03-31-2008 04:12 PM |
| trimmed card? | Archive | Net54baseball Vintage (WWII & Older) Baseball Cards & New Member Introductions | 4 | 01-06-2003 08:17 PM |
| Trimmed SGC Card? | Archive | Net54baseball Vintage (WWII & Older) Baseball Cards & New Member Introductions | 4 | 05-24-2002 09:50 PM |
Threaded Mode