1966 Topps High's - Any uncut sheets or partial sheets known?

[toppcat]

Originally Posted by BillP

I agree with your slit line up. I think that the 3 rows 4 times and 4 rows 3 times makes sense. I also would submit relative to cards 591 and 540, which according to this are the bottom 2 cards on the B slit model that these cards were highly open to damage at the production level.
When you think about the 7th series cards that command premiums somewhat without star power, 591 561 562 544 and maybe 540 and 590 come to mind.
So is it possible that either slit was produced in a different quantity that the other? With miscuts being in packs, the quality control aspect at that time may have been not as much a focus.
Surprised that when the Topps vault opened that some strips were not made available to help in this interesting effort.

Last one, why is the Piersall 565 always offcut. L to R or diamond. It's not on the border.....

Bill

It's safe to assume each slit was printed in the same quantity as the A and B slits were printed on the same master sheet. What happened during transport from the printers (two trips with backs going to lithographers from a first printer, then to Topps), cutting and packaging operations though probably explains more about many short prints than the sheet/slit arrays, especially in a 4/3 3/4 A/B setup. Edge and corner cards were vulnerable to damage and miscuts but there are casualties within the middle of the sheets that must have happened during cutting and packaging. Some type of cutting pattern most likely had outsize influence.