T220 Silver - Uncut Edition

[G1911]

Using the edge pieces, because again, they are easier . I can fit 3 along the top edge. I'm using the cut, little marks in the borders, and little creases or abrasions some have to match a fit, as well as the wear marks in the white edges.

Frayne > Burke > Jordan fit together, with Jordan obviously being the top right corner.

Of the right edge panels, I only have one, Gans. Moore went to the other buyer, the seller yanked Dempsey. Gans does not fit beneath the Jordan.

There are no left edge panels.

On the bottom row, I can solidly put Edwards and McGovern together. there is brown on the tape on the back connecting them, but ignoring this the creasing and wear and cut fit perfectly. I am 99% sure we can put carney to the left of Edwards. My Edwards panel has a crease going off the edge below his knee. This lines up with a crease on the carney, and the damage in the white also lines up. I do not have Carney in hand (another pulled auction), but pretty sure he fits in right here based on the scans and damage locations.

So that's a significant stretch of the top and bottom rows. It seems to me to strongly suggest these were not pass around sheets like the T62 shown earlier. It must be a fairly large sheet or two. I'm hoping I can now piece internal panels together and with border panels, and then compare what I produce with the e229's and check if they fit together.