WWG DiMaggios -- are these the same card?

Peter_Spaeth · #1 01-26-2025, 01:42 PM

If SGC got it wrong, the owner, or Goldin, had a HUGE incentive to get another opinion before auctioning it the first time. Just measure the card.

Lorewalker · #2 01-26-2025, 02:38 PM

Quote:

Originally Posted by Peter_Spaeth

If SGC got it wrong, the owner, or Goldin, had a HUGE incentive to get another opinion before auctioning it the first time. Just measure the card.

Measuring the card only tells you the size. It will not tell you if the card is trimmed. Plenty of full sized cards that are trimmed and many small cards that are not.

If the card had been in a Auth Trimmed or Auth Altered SGC holder and then PSA graded it a 6.5, we would have something to discuss. There is nothing here to disclose or to discuss.

SGC saw the card as being 100% authentic and not altered but too small to give a numeric grade. PSA saw the size of the card to be acceptable and assigned a grade. If the card is smaller than 1/32 of an inch PSA should not have assigned a grade to it.

The description writer should be fired for suggesting the card was trimmed, thereby hurting the sale price for the consignor. The buyer hit is out the park.

Based on the scan I think both companies got it wrong because the scan gives the appearance of a trimmed card but I cannot see the edges.

Peter_Spaeth · #3 01-26-2025, 02:59 PM

My point is simply the owner or Goldin could have measured the card to make a judgment if SGC had the min size right or not, given the huge upside if there was a reasonable chance it could regrade with a number grade. And if they concluded it was within spec, send it in again, don't sell it for a fraction of value. Not commenting on trimmed or not.

Lorewalker · #4 01-26-2025, 03:37 PM

Quote:

Originally Posted by Peter_Spaeth

My point is simply the owner or Goldin could have measured the card to make a judgment if SGC had the min size right or not, given the huge upside if there was a reasonable chance it could regrade with a number grade. And if they concluded it was within spec, send it in again, don't sell it for a fraction of value. Not commenting on trimmed or not.

At least 1 employee of Goldin's does not know what Auth Min Size means so to think they might take the next step and measure the card is a huge stretch.

It is possible the consignor agreed with SGC's call or lacked the interest or sophistication to question SGC's conclusion. Most in the hobby who buy into the slab concept defer entirely to what the TPG concludes.

What cards end up as Min Size varies from grader to grader and grading company to grading company.

I do not like the Min Size "grade". At this point the grading companies have graded so many trimmed and altered cards why not just slap a number grade on a card that is small but has 100% legit cuts from the factory? As I understand it, the entire reason the graders do not do this is to eliminate the perception that they might have slabbed a trimmed card because the card is small. Sort of funny at this point.

Peter_Spaeth · #5 01-26-2025, 03:42 PM

Maybe the best thing would be a number grade with a qualifier for size?

Lorewalker · #6 01-26-2025, 04:57 PM

Quote:

Originally Posted by Peter_Spaeth

Maybe the best thing would be a number grade with a qualifier for size?

Missed this...Yes. Qualify the card as being small but assign a grade. Being cut small, to me, is no different than a card being printed off center.

rhettyeakley · #7 01-26-2025, 07:59 PM

Bottom border looks suspicious.

Peter_Spaeth · #8 01-26-2025, 03:48 PM

Quote:

Originally Posted by Lorewalker

At least 1 employee of Goldin's does not know what Auth Min Size means so to think they might take the next step and measure the card is a huge stretch.

It is possible the consignor agreed with SGC's call or lacked the interest or sophistication to question SGC's conclusion. Most in the hobby who buy into the slab concept defer entirely to what the TPG concludes.

What cards end up as Min Size varies from grader to grader and grading company to grading company.

I do not like the Min Size "grade". At this point the grading companies have graded so many trimmed and altered cards why not just slap a number grade on a card that is small but has 100% legit cuts from the factory? As I understand it, the entire reason the graders do not do this is to eliminate the perception that they might have slabbed a trimmed card because the card is small. Sort of funny at this point.

One would hope their pre war/graded card expert would be the one to write up a card that significant, but I don't know how the business works. Anyhow, at least with hindsight, the prior consignor appears to have left a lot of money on the table. And it sure would be interesting to know who won and submitted it to PSA.

Lorewalker · #9 01-26-2025, 03:55 PM

Quote:

Originally Posted by Peter_Spaeth

One would hope their pre war/graded card expert would be the one to write up a card that significant, but I don't know how the business works.

Lots of questions here...

Did PSA assign a grade to a card that was truly smaller than 1/32 of an inch? Most of us will get cards kicked back for Min Size (assuming card is not trimmed), if they are between 1/64 and 1/32 short.

Who at Goldin wrote the auction description the first time the card was offered to be described as possibly being trimmed?

Was this the same person who wrote the description 3 months later for the card in the 6.5 holder and did not notice they were the same card and should they have noticed?

Is this card actually trimmed and that is why it is small? Harder to answer with the card in the holder but not impossible.

Peter_Spaeth · #10 01-26-2025, 03:59 PM

There are often more questions than answers in this hobby.

oldjudge · #11 01-26-2025, 03:59 PM

I'm pretty sure that Joe T did the second description. I wonder who did the first and if it wasn't Joe then why not? I doubt that anyone at Goldin knows anywhere near as much about vintage cards as Joe.
As to disclosure of the A, if I won the card in the current auction and found out after the fact that it had previously been in an A holder, that Goldin knew this before the auction ended and still failed to disclose this, I am beyond pissed. That would be a great way to potentially lose a deep pocketed bidder. Is there a law that Goldin has to do this--no. The hobby is the Wild West. However, should they disclose this information --I think the clear answer is yes.

Lorewalker · #12 01-26-2025, 04:13 PM

Quote:

Originally Posted by oldjudge

I'm pretty sure that Joe T did the second description. I wonder who did the first and if it wasn't Joe then why not? I doubt that anyone at Goldin knows anywhere near as much about vintage cards as Joe.
As to disclosure of the A, if I won the card in the current auction and found out after the fact that it had previously been in an A holder, that Goldin knew this before the auction ended and still failed to disclose this, I am beyond pissed. That would be a great way to potentially lose a deep pocketed bidder. Is there a law that Goldin has to do this--no. The hobby is the Wild West. However, should they disclose this information --I think the clear answer is yes.

If Joe T, who is apparently admired here by everyone, did the PSA 6.5 write up then he had to have done the SGC Min Size write up. He has been there for more than 6 months. If he called this card trimmed based on SGC assessment, not sure he is the guy I would go to for advice in the realm of grading. You are less forgiving than I would be but if he also missed that he took in the SGC version of this card 3 months earlier, you might want to reconsider relying on him.

As rare as this card might be I don't think someone dropped the ball not connecting the two cards to one another and I just do not see this as a failure to disclose based on the info we have... which is next to nothing.

What if PSA is entirely right and this card is EXMT+ and it meets the size requirement and SGC was entirely wrong? Is disclosure needed? The only difference in opinion the two companies have is that one says it did not meet their size requirement and the other, who has another set of standards for size, says it does meet the requirements?

oldjudge · #13 01-26-2025, 04:29 PM

What if SGC was right? Provide the info to potential buyers and let them decide.

Lorewalker · #14 01-26-2025, 04:36 PM

Quote:

Originally Posted by oldjudge

What if SGC was right? Provide the info to potential buyers and let them decide.

Ask Joe why he didn't. Why you are at is ask him why he suggested the card might be trimmed in his description on the SGC example.

I do not think Goldin dropped the ball not disclosing. Both companies see the card as legit. One felt it was too small, the other did not. At that point any interested buyer could just use their eyes...and they should.

bigfanNY · #15 01-27-2025, 01:20 PM

To drop my 2 cents in I favor transparency. And Given card is over 100k with juice now. If I was a bidder I would want to know. 2 TPG's ( both owned by same company) disagreed so significantly. Because down the road it could come up when up for sale next time. If this was a case of one TPG or same TPG saying 5 vs 6.5 that's one thing, but A vs 6.5...I would tell and I would want to know

Peter_Spaeth · #16 01-27-2025, 01:30 PM

That it would be important to at least some people is the very reason things like this don't get disclosed, despite all the justifications people offer.

ValKehl · #17 01-26-2025, 09:21 PM

Quote:

Originally Posted by oldjudge

As to disclosure of the A, if I won the card in the current auction and found out after the fact that it had previously been in an A holder, that Goldin knew this before the auction ended and still failed to disclose this, I am beyond pissed. That would be a great way to potentially lose a deep pocketed bidder. Is there a law that Goldin has to do this--no. The hobby is the Wild West. However, should they disclose this information --I think the clear answer is yes.

+1

CardPadre · #18 01-26-2025, 09:55 PM

Would anyone agree that if SGC graded that card 10 times (with a fresh look each time, not knowing they had graded it before) you would probably come out with trimmed, min size, VG-3, VG-EX-4, and EX-5 included in those results?

Everyone knows and complains that there is no consistency or reliability in grading and that's why previous grades are not relevant (in my opinion) in selling a graded card.

And "min size" is the most irrelevant assessment since no TPG specifies what constitutes "significantly undersized" and they all are known to have numerically graded a card they had previously min sized. It's so ludicrous, that it just can't be considered relevant.

Snowman · #19 01-26-2025, 11:01 PM

You guys are hilarious.

For the record, "Minimum Size Not Met" means the card DOES NOT bear evidence of trimming. If it did, they would put "Evidence of Trimming" on the label.

I have a NM+ card that I've submitted 5 times and it has gotten 5 different grades: 6.5, 4.5, Authentic, 6, 5. What a card was graded previously is completely irrelevant. Graders get it wrong far too often for that to matter. The idea that a card's previous holder/opinion should be forever attached to it is pretty hilarious. Good luck with that.

Zero chance Goldin takes this down and zero chance PSA decertifies it.

Maybe instead of spending all that energy into crying about someone else profiting from a card you should learn how to grade yourself and then spend that time finding cards that have been assaulted by some new inexperienced grader that had no clue what he was doing when he graded it.

Lorewalker · #20 01-26-2025, 11:05 PM

Quote:

Originally Posted by CardPadre

Would anyone agree that if SGC graded that card 10 times (with a fresh look each time, not knowing they had graded it before) you would probably come out with trimmed, min size, VG-3, VG-EX-4, and EX-5 included in those results?

Old Judge would expect disclosure on all those results too. Imagine auction write ups if that ever happens.

Quote:

Originally Posted by CardPadre

Everyone knows and complains that there is no consistency or reliability in grading and that's why previous grades are not relevant (in my opinion) in selling a graded card.

I agree to a certain point. Certainly in the case of this card the previous grade by SGC is not remotely relevant. If I consigned the card in the SGC holder I would be more than upset...with myself.

Quote:

Originally Posted by CardPadre

And "min size" is the most irrelevant assessment since no TPG specifies what constitutes "significantly undersized" and they all are known to have numerically graded a card they had previously min sized. It's so ludicrous, that it just can't be considered relevant.

This is 100% correct. And it is a moving target at both PSA and SGC. I would not call 1/32 of an inch significantly undersized for a baseball card until we get to possibly cards the size of T206s.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
SGC DiMaggios	samosa4u	Net54baseball Vintage (WWII & Older) Baseball Cards & New Member Introductions	5	11-12-2020 12:52 PM
10 DiMaggios	theshleps	Autograph Forum- Primarily Sports	14	06-05-2019 06:27 PM
3 DiMaggios Postcard	Ben Yourg	Baseball Memorabilia B/S/T	0	07-16-2018 08:02 PM
WTB: Pre-War Joe DiMaggios...	davetruth	1920 to 1949 Baseball cards- B/S/T	3	05-28-2014 07:51 PM
Some more Joe DiMaggios...opinions needed!	Big Six	Autograph Forum- Primarily Sports	6	07-03-2013 09:20 AM